Differences

This shows you the differences between two versions of the page.

--- configuration_reset [2021/07/20 15:52] – [Clear project data method] emozolyak
+++ configuration_reset [2022/01/14 21:40] (current) – ↷ Links adapted because of a move operation 127.0.0.1
@@ Line 1: / Line 1: @@
+{{ network:menu-icon-reset.png?nolink&40|}}
 ====== Configuration reset ======
@@ Line 12: / Line 13: @@
 ===== Project configuration reset =====
-==== Clear project data method ====
+Project configuration reset - can be made in 3 ways:
-Project configuration reset - can be made in 2 ways:
+  *from the project itself - use Setup / Clean project & data menu
-  *from the project itself - Setup / Clean project & data menu
   *from the network configuration ( WebHMI/Network/ Reset menu)
+  *remove SD card and format it
+==== Clear project data method ====
+=== Fw versions 3.6 and higher (popup setup window) ===
+{{ network:setup_menu_prj_clean.png }}
-{{clear_project.png?direct}}
+{{ network:clean_project_options_highlighted.png?direct&600 |}}
-If you select "WebHMI project configuration and all collected data" option system will reset all settings and collected data. Network setting will not be affected.
+=== Fw version 3.5 and low (side setup menu) ===
+{{network:clear_project.png?direct}}
+<wrap em>The system will reset all settings and collected data. Network setting will not be affected.
+</wrap>
 ==== From networking menu method ====
-{{::net_conf_reset.png?direct|}}
+{{network:net_conf_reset.png?direct|}}
 ===== Network settings reset =====
 The network configuration reset - can only be made using special routine with hardware 'Reset' button. To reset the network settings, press and hold the 'Reset' button (located on the front panel of the device) when the device is turned off. Then turn the device on while keeping button pressed.
-{{ ::net_conf_button.png?direct&200 |}}
+{{ network:net_conf_button.png?direct&200 |}}
 After a while (approximately after 20-30 seconds, depending on the version of the firmware maybe longer) the red 'Error' LED will flash. Continue to hold down the 'Reset' button. After the first flashing, the 'Error' LED goes out and then lights up for a few seconds again.