Differences

This shows you the differences between two versions of the page.

--- configuration_reset [2019/01/08 12:26] – [Network settings reset] emozolyak
+++ configuration_reset [2022/01/14 21:40] (current) – ↷ Links adapted because of a move operation 127.0.0.1
@@ Line 1: / Line 1: @@
+{{ network:menu-icon-reset.png?nolink&40|}}
 ====== Configuration reset ======
-There are two parts of the WebHMI's configuration - Project configuration and Network configuration. The project configuration essentially is the 'HMI' part, which defines how the project runs and looks for the users, while Network configuration defines settings of the WebHMI's communication interfaces enabling access from/to external devices.
+There are two parts of the WebHMI's configuration - __Project__ configuration and __Network__ configuration. The project configuration essentially is the 'WebHMI' part, which defines how the project runs and looks for the users, while Network configuration defines settings of the WebHMI's LAN, WAN, VPN etc. networking configuration.
-  *Project configuration reset - can be made in 2 ways: from the project itself ( Setup / Clean project menu), or from the network configuration ( WebHMI / Reset menu)
-  *Network configuration reset - can only be made using special routine with hardware 'Reset' button.
@@ Line 12: / Line 13: @@
 ===== Project configuration reset =====
+Project configuration reset - can be made in 3 ways:
+  *from the project itself - use Setup / Clean project & data menu
+  *from the network configuration ( WebHMI/Network/ Reset menu)
+  *remove SD card and format it
 ==== Clear project data method ====
-The menu item Clear project (**Setup / Clear project**) allows you to clear project data:
+=== Fw versions 3.6 and higher (popup setup window) ===
+{{ network:setup_menu_prj_clean.png }}
-{{clear_project.png?direct}}
+{{ network:clean_project_options_highlighted.png?direct&600 |}}
-If you select "WebHMI project configuration and all collected data" option system will reset all settings and collected data. Network setting will not be affected.
+=== Fw version 3.5 and low (side setup menu) ===
+{{network:clear_project.png?direct}}
+<wrap em>The system will reset all settings and collected data. Network setting will not be affected.
+</wrap>
 ==== From networking menu method ====
-{{::net_conf_reset.png?direct|}}
+{{network:net_conf_reset.png?direct|}}
 ===== Network settings reset =====
-To reset the network settings, press and hold the 'Reset' button (located on the front panel of the device) when the device is turned on.
+The network configuration reset - can only be made using special routine with hardware 'Reset' button. To reset the network settings, press and hold the 'Reset' button (located on the front panel of the device) when the device is turned off. Then turn the device on while keeping button pressed.
-{{ ::net_conf_button.png?direct&200 |}}
+{{ network:net_conf_button.png?direct&200 |}}
 After a while (approximately after 20-30 seconds, depending on the version of the firmware maybe longer) the red 'Error' LED will flash. Continue to hold down the 'Reset' button. After the first flashing, the 'Error' LED goes out and then lights up for a few seconds again.