User Tools

Site Tools


wetelecom_wm-d200

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
wetelecom_wm-d200 [2019/01/22 11:05] – created emozolyakwetelecom_wm-d200 [2022/01/15 23:35] (current) – ↷ Links adapted because of a move operation 127.0.0.1
Line 3: Line 3:
 Lets go through the WeTelecom WM-D200 CDMA-modem tune-up procedure for MTS (Ukraine). Lets go through the WeTelecom WM-D200 CDMA-modem tune-up procedure for MTS (Ukraine).
  
-{{ ::wetelecom-wm-d200.png?direct&200 |}}+{{ network:wetelecom-wm-d200.png?direct&300 |}}
  
 0. Disconnect the USB Modeswitch as described on the page "Особенности работы с некоторыми модемами". 0. Disconnect the USB Modeswitch as described on the page "Особенности работы с некоторыми модемами".
Line 9: Line 9:
 1. Go to the network settings interface. Open the Network-> Interfaces page. Click the "Add new interface" button. 1. Go to the network settings interface. Open the Network-> Interfaces page. Click the "Add new interface" button.
  
 +{{ network:p_net_scr_1.png?direct&600 |}}
 +
 +2. Set "3G" as the interface's name. Select "UMTS/GPRS/EV-DO" protocol type. Push "Submit".
 +
 +{{ network:p_net_scr_2.png?direct&600 |}}
 +
 +3. Select following options:
 +  *Protocol: UMTS/GPRS/EV-DO
 +  *Modem device: /dev/ttyUSB1 (device number ttyUSB1/2/3/4/... depends on USB-devices quantity in the system and particular modem - should be selected experimentally)
 +  *Service Type: CDMA/EV-DO
 +  *APN: mtsconnect
 +  *PIN: 0000
 +  *PAP/CHAP username: mobile
 +  *PAP/CHAP password: internet
 +
 +{{ network:mts_conn_3.png?direct&600 |}}
 +
 +4. If VPN is used, it's necessary to set main gateway metric. It should be less than VPN's one.
 +
 +5. In the Firewall settings, specify a WAN zone to exclude incoming connections from the Internet. Usually, they are not needed and bring additional security risks.
 +
 +{{ network:mts_conn_firewall.png?direct&600 |}}
 +
 +6. Click "Save and apply". The settings will be applied. If everything is done correctly, on the Network-> Interfaces page you will see a new "3G" interface with the connection installed.
 +
 +{{ network:p_net_scr_6.png?direct&600 |}}
 +
 +7. To check the connection to the Internet, go to the Network-> Diagnostics page and click the Traceroute button. If the Internet connection works correctly, you will see the package path to the specified server (by default openwrt.org). 
 +
 +{{ network:trace_route_3g_check.png?direct&600 |}}
  
  
wetelecom_wm-d200.1548155155.txt.gz · Last modified: 2019/01/22 11:05 by emozolyak

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki