supported_protocols
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
supported_protocols [2019/01/09 14:32] – [The protocols supported] emozolyak | supported_protocols [2019/01/09 14:37] – [The protocols supported] emozolyak | ||
---|---|---|---|
Line 6: | Line 6: | ||
*[[adv_protocol| Advantech Adam serial protocol]] | *[[adv_protocol| Advantech Adam serial protocol]] | ||
*[[df1| Allen-Bradley DF1]] | *[[df1| Allen-Bradley DF1]] | ||
+ | *[[eth_ip| Allen-Bradley Ethernet/ | ||
*[[bacnet| Bacnet]] | *[[bacnet| Bacnet]] | ||
*[[delta_dvp|Delta Electronics DVP protocol]] | *[[delta_dvp|Delta Electronics DVP protocol]] | ||
Line 14: | Line 15: | ||
*[[siemens_iso| Siemens S7 Communicatoin (Iso-Over-Tcp) ]] | *[[siemens_iso| Siemens S7 Communicatoin (Iso-Over-Tcp) ]] | ||
*[[1wire| 1Wire bus for temperature sensors]] | *[[1wire| 1Wire bus for temperature sensors]] | ||
+ | *[[broadlink_sps3| Broadlink SPS3]] | ||
Line 47: | Line 49: | ||
- | ===== Broadlink SP3S ===== | ||
- | {{:: | ||
- | Since version 2.10, WebHMI supports the Broadlink SP3S smart socket protocol. | ||
- | At the moment, supported protocol data are - state of the socket (on / off) and the power consumption. | ||
- | |||
- | Following addressing map for the registers of the Broadlink SP3S socket is adopted: | ||
- | ^Register address ^Description ^Data type ^Reading/ | ||
- | |DO1 |Digital Output 1. Allows switching on/off and read its state |Bit |Read/ | ||
- | |P1 |Power Consumption, | ||
===== Implemented using custom protocol mechanism ===== | ===== Implemented using custom protocol mechanism ===== |
supported_protocols.txt · Last modified: 2022/08/24 08:54 by emozolyak