first_power_up
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
first_power_up [2022/05/30 14:33] – [Preparation for work] emozolyak | first_power_up [2024/01/16 09:19] (current) – [Preparation for work] emozolyak | ||
---|---|---|---|
Line 4: | Line 4: | ||
Before you can start WebHMI for the first time, you need to take some preparatory steps. | Before you can start WebHMI for the first time, you need to take some preparatory steps. | ||
+ | <WRAP center round important 60%> | ||
+ | The storage device is set by default to SD card. You can use USB drives either. If you change storage device and install different one from the currently set in the WebHMI' | ||
+ | {{: | ||
+ | </ | ||
- | | + | |
+ | | ||
- By default, the WebHMI' | - By default, the WebHMI' | ||
- When connecting the RS485 bus, make sure that not only lines A and B are connected but also their common wire that equalizes the potentials between the WebHMI and other devices on the bus is connected too. This is especially true if the line is long or the devices are powered by different power sources. | - When connecting the RS485 bus, make sure that not only lines A and B are connected but also their common wire that equalizes the potentials between the WebHMI and other devices on the bus is connected too. This is especially true if the line is long or the devices are powered by different power sources. |
first_power_up.1653921230.txt.gz · Last modified: 2022/05/30 14:33 by emozolyak