Differences

This shows you the differences between two versions of the page.

--- first_power_up [2021/08/05 09:36] – [First power-up] emozolyak
+++ first_power_up [2022/05/30 14:33] – [Preparation for work] emozolyak
@@ Line 1: / Line 1: @@
 ====== First power-up ======
-{{ :power_up.png?nolink50|}}
+{{ network:power_up.png?nolink50|}}
 ===== Preparation for work =====
@@ Line 15: / Line 15: @@
 If the SD card is not detected, the WebHMI will flash three LEDs (Error, WWW, and VPN). After 20 flashes, the system boots but not all services are started. During the next minute, watchhog will see that there is no SD card and will reboot the system. In this way, the system will constantly reboot until an SD card is inserted.
+==== Front panel conteols designations ====
+{{ ::hw-setup:webhmi-fpanel-test.png?direct&400 |}}
 ===== Access to the web interface =====
@@ Line 25: / Line 29: @@
 WebHMI has 2 Ethernet ports: a LAN configured as a DHCP server and a WAN configured as a DHCP client with incoming connections disabled by default in the firewall. Thus, access to the web interface of the system can only be obtained from the LAN port.
-{{ ::connect-lan.jpg?direct&912 |}}
+{{ network:connect-lan.jpg?direct&912 |}}
 To get access to web interface please configure your network adapter either in DHCP client mode or with following settings:
@@ Line 45: / Line 49: @@
 ^ Password | admin |
-{{ ::signin.png?direct&400 |}}
+{{ network:signin.png?direct&400 |}}
 On login screen at the bottom section you can find current version of firmware and link to network setup interface.
@@ Line 56: / Line 60: @@
 === Moon color theme ===
-{{ ::reg_list_fw_40.png?direct&800 |}}
+{{ network:reg_list_fw_40.png?direct&800 |}}
 === Mars color theme ===
-{{ ::reg_list_fw_40_mars_skin.png?direct&800 |}}
+{{ network:reg_list_fw_40_mars_skin.png?direct&800 |}}
@@ Line 66: / Line 70: @@
 ==== An "after login" project view before 3.6 fw====
-{{ :new-signin.png?direct&800 |}}
+{{ network:new-signin.png?direct&800 |}}