User Tools

Site Tools


connections

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
connections [2021/07/21 12:42] – [Add preset device connections] emozolyakconnections [2021/08/06 09:37] emozolyak
Line 1: Line 1:
 ====== Connections ====== ====== Connections ======
 +{{  :onnection_new_logo_.png?nolnk&40}}
 The connection determines which communication driver and what parameters WebHMI will use to exchange data with the equipment. The list of the connection settings and their meaning is given in this section.  The connection determines which communication driver and what parameters WebHMI will use to exchange data with the equipment. The list of the connection settings and their meaning is given in this section. 
  
Line 65: Line 66:
 There are preset connections you can add in one-click from the register list tree. There are preset connections you can add in one-click from the register list tree.
  
-{{ ::preset_device_insert.png?direct&800 |}}+{{ ::preset_device_insert.png?direct&600 |}}
  
 <wrap em>After the creation, you need to edit connection to finish it creation: replace default net address  <wrap em>After the creation, you need to edit connection to finish it creation: replace default net address 
-enable the connection.</wrap>+and enable the connection.</wrap>
  
 ==== Diagnostic preset registers ==== ==== Diagnostic preset registers ====
Line 74: Line 75:
 It is called "WebHMI Health registers". It is called "WebHMI Health registers".
  
-{{ conn:add:health_reg.png?direct&800 |}}+{{ ::add_health_registers.png?direct&600 |}}
  
- It is a bunch of registers, which intended to show the status of WebHMI.  +It is a bunch of registers, which intended to show the status of WebHMI. The logging option is turned on for them, so you can immediately analize the system behaviour in custom graphs.
-{{ conn:add:health_reg_works.png?direct&800 |}} +
-It is also logging enabled by default to make it possible create a graph with average load or input voltage for example. +
-{{ conn:add:create_custom_graph.png?direct&800 |}} +
-{{ conn:add:custom_graph_settings.png?direct&800 |}}+
  
 +{{ ::health_registers_example.png?direct&600 |}}
  
-If some device can be nested inside another (e.g. 7bit(tm) AipPoint sensor inside 7bit(tm) AirGate MQTT connection or WebHMI Health registers inside other WebHMI internal connection) the option to create a category in that connection will be offered. +If the registers of the device being added can be nested inside another similar connection (e.g. 7bit(tm) AipPoint sensor inside 7bit(tm) AirGate MQTT connection or WebHMI Health registers inside other WebHMI internal connection) the option to create a category in that connection will be offered.  
 + 
 +{{ ::add_device_1.png?direct&600 |}}
  
-{{ ::add_device_1.png?direct&400 |}} 
  
-  Don't forget to correct the default settings for network address, port etc. after adding a device.  
  
  
connections.txt · Last modified: 2024/02/02 08:48 by emozolyak

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki