In the WebHMI project it is possible to mark some registers as resource meter readings. Then in the Level2 reports various reports regarding resource consumption will be available.
In the register's properties tab, there is a special Resources tab for this:
You can choose meter resource:
Title: this meter name will be shown in the L2 reports.
Main meter: If the meter is selected as Main, then other meters of the same type will be considered as contributors to the whole resource consumption.
Send meter reading must be checked for using resource reports in Level2.
When the facility being monitored has data on its square you can extimate resource consumption per square meter of total area or commercial area.
The consumption figures can be shown both in engineering units and in money units. For this, you should setup rates and link them to the resource. Then in the consumption reports you will see correct figures in money units.
Use Add button to add new rate:
On the rate edit page, you setup:
After WebHMI node is pinned to a specific map location in its setup page:
Node location and status register linkage is set on the node's setup Map tab:
In this report you can view consumption data for a given resource at some facility over the period of time. If there are many meters for the resource, their individula shares in total consumption can be shown. Below the example of this report.
In this report you select:
You can also analize the cost spent for some resource by switching this button:
Built report can be printed or saved to Excel sheet.
It is based on previous, but for comparing two similar systems. See more on this More details .
It is simplest report to show meters readings over the periods of time. More details ...
In this report, all nodes consuming a certain type of resource can be shown with their respective contribution to the total consumption. The report shows total consumption or per square meter of a building.
In this report consumption chart is shown as a function of temperature. More details...
When there are limits set for the resource condumption, this report will show how current consumpion for the period fits to the planned limit for this period. More details ...