scylar
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
scylar [2019/01/09 11:00] – emozolyak | scylar [2022/01/15 15:44] (current) – ↷ Links adapted because of a move operation 127.0.0.1 | ||
---|---|---|---|
Line 8: | Line 8: | ||
Wiring diagram: | Wiring diagram: | ||
- | {{ :: | + | {{ network: |
Setup the connection for the meter as follows: | Setup the connection for the meter as follows: | ||
- | {{ :: | + | {{ network: |
The bus address | The bus address | ||
- | {{ :: | + | {{ network: |
- | {{ :: | + | {{ network: |
This protocol can read the following heatmeter' | This protocol can read the following heatmeter' | ||
Line 33: | Line 33: | ||
|Error run hours| ERH0 | hours | | |Error run hours| ERH0 | hours | | ||
- | The driver | + | The driver |
in register properties. | in register properties. | ||
| | ||
Line 40: | Line 40: | ||
Before testing the protocol in the field, it's preferrable to test it in a lab (if you have a meter on-hand). | Before testing the protocol in the field, it's preferrable to test it in a lab (if you have a meter on-hand). | ||
- | To simulate temperatures you can use resistors or potentiometers, | + | To simulate temperatures you can use resistors or potentiometers, |
- | {{ :: | + | {{ network: |
+ | |||
+ | == Custom protocol (driver) code block == | ||
<code lua> | <code lua> |
scylar.1547031603.txt.gz · Last modified: 2019/01/09 11:00 by emozolyak