scylar
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
scylar [2019/01/09 10:16] – emozolyak | scylar [2022/01/15 15:44] (current) – ↷ Links adapted because of a move operation 127.0.0.1 | ||
---|---|---|---|
Line 8: | Line 8: | ||
Wiring diagram: | Wiring diagram: | ||
- | {{ :: | + | {{ network: |
+ | Setup the connection for the meter as follows: | ||
+ | {{ network: | ||
+ | |||
+ | The bus address | ||
+ | {{ network: | ||
+ | |||
+ | {{ network: | ||
+ | |||
+ | This protocol can read the following heatmeter' | ||
+ | |||
+ | ^ Parameter ^ Register address in project ^ Units ^ | ||
+ | |Energy | ||
+ | |Energy tariff1 | ||
+ | |Energy tariff2 | ||
+ | |Volume | ||
+ | |Power | PWR0 | 0.001 kW | | ||
+ | |Flow | CFL0 | 0.001 m3/h | | ||
+ | |Forward temperature | FWT0 | 0.1 °C | | ||
+ | |Return temperature | RET0 | 0.1 °C | | ||
+ | |Operational days | OPD0 | days | | ||
+ | |Error run hours| ERH0 | hours | | ||
+ | |||
+ | The driver returns integer values. You should scale them appropriately to get exact values using Multiplier field | ||
+ | in register properties. | ||
+ | | ||
+ | |||
+ | == Driver test procedure == | ||
+ | |||
+ | Before testing the protocol in the field, it's preferrable to test it in a lab (if you have a meter on-hand). | ||
+ | To simulate temperatures you can use resistors or potentiometers, | ||
+ | |||
+ | {{ network: | ||
+ | |||
+ | == Custom protocol (driver) code block == | ||
<code lua> | <code lua> |
scylar.1547029001.txt.gz · Last modified: 2019/01/09 10:16 by emozolyak