Differences

This shows you the differences between two versions of the page.

--- remote_service_access [2018/12/07 15:34] – [Creating a node in Level2 for service PC] emozolyak
+++ remote_service_access [2018/12/10 09:41] – [Establishing communication with remote devices behind the gateway via TCP / IP] emozolyak
@@ Line 41: / Line 41: @@
 Edit its settings according to Level2 settings:
-{{::vpn_win10_add_3_modifyed.png?direct}}
+{{::vpn_win10_add_eng.png?direct}}
 And check adapter properties:
@@ Line 55: / Line 55: @@
 {{ ::vpn_win10_connected.png?direct&400 |}}
-After connecting PC to the VPN, check
+After connecting the PC to the VPN, "ping" the remote WebHMI node(s), which were allowed to access to in Routing tab:
+{{ ::routing_target_1.png?direct&600 |}}
+You can check its IP in the node's (//System with S7-1200 PLC//) Information tab:
+{{check_routing_target_ip.gif}}
 ===== Establishing communication with remote devices behind the gateway via TCP / IP =====
@@ Line 64: / Line 69: @@
-You must enable the Virtual IP address function for the specified WebHMI node. Go the Setup / Level2 menu and switch Virtual IPs lever on:
+You must **enable the Virtual IP address function** for the specified WebHMI node. Go the __WebHMI's__ Setup / Level2 menu and switch Virtual IPs lever on:
   -input the remote PLC's IP address it was assigned in that local network (192.168.0.210)