Differences

This shows you the differences between two versions of the page.

--- first_power_up [2018/07/11 09:06] – [Login to the web interface] akuzmuk
+++ first_power_up [2021/07/20 14:33] – [Login to the web interface] emozolyak
@@ Line 19: / Line 19: @@
 ==== Wireless connection over Wi-Fi ====
-By default, the WebHMI wireless interface is configured in an access point mode with DHCP enabled and disabled security. Thus, your laptop or tablet can simply be connected to the WebHMI network (the settings will be made automatically), then go to the site with the address: **192.168.1.1**
+By default, the WebHMI wireless interface is configured in an access point mode with DHCP enabled and disabled security. Thus, your laptop or tablet can simply be connected to the **WebHMI** network (the settings will be made automatically), then go to the site with the address: **192.168.1.1**
 ==== Wired connection ====
 WebHMI has 2 Ethernet ports: a LAN configured as a DHCP server and a WAN configured as a DHCP client with incoming connections disabled by default in the firewall. Thus, access to the web interface of the system can only be obtained from the LAN port.
-{{ ::connect-lan.jpg?direct&600 |}}
+{{ ::connect-lan.jpg?direct&912 |}}
 To get access to web interface please configure your network adapter either in DHCP client mode or with following settings:
@@ Line 48: / Line 48: @@
 On login screen at the bottom section you can find current version of firmware and link to network setup interface.
+After logging in by default, you will be taken to the registers configuration page:
-After logging in by default, you will be taken to the registers configuration page (in the Setup/Registers menu). In the future, the whole project is configured through the side submenu "Setup".
+==== An "after login" project view after 3.6 fw ====
-{{ :new-signin.png?direct&912 |}}
+ (in the Setup/Registers menu). In the future, the whole project is configured through the side submenu "Setup".
+{{ ::reg_list_fw_40.png?direct&800 |}}
+==== An "after login" project view before 3.6 fw====
+{{ :new-signin.png?direct&800 |}}