User Tools

Site Tools


Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
eth_ip [2019/03/04 09:33]
emozolyak
eth_ip [2019/03/04 09:33] (current)
emozolyak
Line 10: Line 10:
 ^Program block scope in PLC program| Use register address in the following format: PROGRAM:​MainProgram.Counter_2.PRE. Here “MainProgram” is a program name.| ^Program block scope in PLC program| Use register address in the following format: PROGRAM:​MainProgram.Counter_2.PRE. Here “MainProgram” is a program name.|
  
-  ATTENTION: Check your slot number parameter of the connection properties ​match to that one in PLC settings.+  ATTENTION: Check your slot number parameter of the connection properties ​matches ​to that one in PLC settings.
  
 {{ ::​eth_ip_slot.png?​direct&​600 |}} {{ ::​eth_ip_slot.png?​direct&​600 |}}

Page Tools