Differences

This shows you the differences between two versions of the page.

--- delta_servo [2019/01/08 13:11] – emozolyak
+++ delta_servo [2019/01/08 13:16] – emozolyak
@@ Line 5: / Line 5: @@
 The Delta Electronics servo drives can be monitored / controld via Modbus and Webhmi. The communications settings are given in the #3 group of parameters:
 ^^^
-^ 03-00 |Network address |
+|**03-00** |Network address |
-^ 03 - 01 |Speed |
+| **03-01** |Speed |
-^ 03 - 02 |Protocol |
+| **03-02** |Protocol |
-^ 03 - 05 |Interface 0:RS232, 1:RS485 (485 only possible for multi-drop) |
+| **03-05** |Interface 0:RS232, 1:RS485 (485 only possible for multi-drop) |
-^ 03 - 06 | 03-06 (HR30C) defines the source for the digital inputs of the drive - wether they are "real" external inputs, or 'force' values got via Modbus. Bits 0..7 of this paramter corresponds to real digital inputs DI1..DI8. Writing 0 sets "real" mode, 1 - 'force' input from Modbus paramter 4-07 (HR40E) (it is a bit mask). |
+| **03-06** | 03-06 (HR30C) defines the source for the digital inputs of the drive - wether they are "real" external inputs, or 'force' values got via Modbus. Bits 0..7 of this paramter corresponds to real digital inputs DI1..DI8. Writing 0 sets "real" mode, 1 - 'force' input from Modbus paramter 4-07 (HR40E) (it is a bit mask). |
-Modbus адреса всех параметров указаны в описании каждого пользовательского параметра, вместе с типом данных и диапазоном возможных значений:
+Modbus adresses of all parameters are provided in the manual with its datatype and valid range:
 {{ ::mb_map_servo.png?direct&600 |}}