danfoss_control
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
danfoss_control [2019/01/04 13:32] – emozolyak | danfoss_control [2019/01/04 13:34] – emozolyak | ||
---|---|---|---|
Line 20: | Line 20: | ||
***REF** Bus reference register - frequency setpoint HR50009 | ***REF** Bus reference register - frequency setpoint HR50009 | ||
***STW** status word - accessible bitwise on C32..C47 addresses with Read coils or HR50199 with holding register read | ***STW** status word - accessible bitwise on C32..C47 addresses with Read coils or HR50199 with holding register read | ||
- | **MAV** actual frequency HR50209. | + | |
More details on working with Danfoss FC drives are described in document MG.02.A4.02 VLT® Micro Drive FC 51 Operating Instructions. Below is a table with parameters. The parameter numbers specified in these tables must be specified in the register settings with an offset of -1. For example, the Bus reference register (REF) in the documentation has the address 50000, but in the WebHMI you set it as HR49999. | More details on working with Danfoss FC drives are described in document MG.02.A4.02 VLT® Micro Drive FC 51 Operating Instructions. Below is a table with parameters. The parameter numbers specified in these tables must be specified in the register settings with an offset of -1. For example, the Bus reference register (REF) in the documentation has the address 50000, but in the WebHMI you set it as HR49999. | ||
Line 36: | Line 36: | ||
In the frequency converter, the frequency values are presented as follows: the frequency 50 Hz (100% of the scale) corresponds to the number 16384. Negative values are also a number in binary complementary form (two's complement). Therefore, to correctly display the frequency and its task for the registers, it is necessary to use the multiplier 50/16384 = 0.0030517578125, | In the frequency converter, the frequency values are presented as follows: the frequency 50 Hz (100% of the scale) corresponds to the number 16384. Negative values are also a number in binary complementary form (two's complement). Therefore, to correctly display the frequency and its task for the registers, it is necessary to use the multiplier 50/16384 = 0.0030517578125, | ||
- | По [[ https:// | + | There is a [[ https:// |
{{:: | {{:: | ||
danfoss_control.txt · Last modified: 2022/01/15 14:10 by 127.0.0.1