Differences

This shows you the differences between two versions of the page.

--- connections [2021/07/21 13:02] – [Diagnostic preset registers] emozolyak
+++ connections [2021/08/06 09:37] – emozolyak
@@ Line 1: / Line 1: @@
 ====== Connections ======
+{{  :onnection_new_logo_.png?nolnk&40}}
 The connection determines which communication driver and what parameters WebHMI will use to exchange data with the equipment. The list of the connection settings and their meaning is given in this section.
@@ Line 76: / Line 77: @@
 {{ ::add_health_registers.png?direct&600 |}}
-It is a bunch of registers, which intended to show the status of WebHMI. The loggin option is turned on for them, so you can immediatly analize the system behaviour in custom graphs.
+It is a bunch of registers, which intended to show the status of WebHMI. The logging option is turned on for them, so you can immediately analize the system behaviour in custom graphs.
 {{ ::health_registers_example.png?direct&600 |}}
-If some device can be nested inside another (e.g. 7bit(tm) AipPoint sensor inside 7bit(tm) AirGate MQTT connection or WebHMI Health registers inside other WebHMI internal connection) the option to create a category in that connection will be offered.
+If the registers of the device being added can be nested inside another similar connection (e.g. 7bit(tm) AipPoint sensor inside 7bit(tm) AirGate MQTT connection or WebHMI Health registers inside other WebHMI internal connection) the option to create a category in that connection will be offered.
+{{ ::add_device_1.png?direct&600 |}}
-{{ ::add_device_1.png?direct&400 |}}
-  Don't forget to correct the default settings for network address, port etc. after adding a device.