connections
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
connections [2021/07/21 12:41] – [Add preset device connections] emozolyak | connections [2021/07/21 13:11] – [Diagnostic preset registers] emozolyak | ||
---|---|---|---|
Line 65: | Line 65: | ||
There are preset connections you can add in one-click from the register list tree. | There are preset connections you can add in one-click from the register list tree. | ||
- | {{ :: | + | {{ :: |
- | <wrap em>After the creation, you need to edit connection to finish it creation | + | <wrap em>After the creation, you need to edit connection to finish it creation: replace default net address |
+ | and enable the connection.</ | ||
==== Diagnostic preset registers ==== | ==== Diagnostic preset registers ==== | ||
Line 73: | Line 74: | ||
It is called " | It is called " | ||
- | {{ conn:add:health_reg.png? | + | {{ ::add_health_registers.png? |
- | It is a bunch of registers, which intended to show the status of WebHMI. | + | It is a bunch of registers, which intended to show the status of WebHMI. |
- | {{ conn: | + | |
- | It is also logging enabled by default to make it possible create a graph with average load or input voltage | + | |
- | {{ conn: | + | |
- | {{ conn: | + | |
+ | {{ :: | ||
- | If some device can be nested inside another (e.g. 7bit(tm) AipPoint sensor inside 7bit(tm) AirGate MQTT connection or WebHMI Health registers inside other WebHMI internal connection) the option to create a category in that connection will be offered. | + | If the registers of the device |
+ | |||
+ | {{ :: | ||
- | {{ :: | ||
- | Don't forget to correct the default settings for network address, port etc. after adding a device. | ||
connections.txt · Last modified: 2024/02/02 08:48 by emozolyak