Differences

This shows you the differences between two versions of the page.

--- connections [2021/07/21 12:37] – [Serial networks] emozolyak
+++ connections [2021/07/21 13:02] – [Diagnostic preset registers] emozolyak
@@ Line 65: / Line 65: @@
 There are preset connections you can add in one-click from the register list tree.
-{{ ::preset_device_insert.png?direct&800 |}}
+{{ ::preset_device_insert.png?direct&600 |}}
-There is a few device presets.
+<wrap em>After the creation, you need to edit connection to finish it creation: replace default net address
+and enable the connection.</wrap>
-After the creation will be done, you need to edit connection to finish it creation.
-{{ conn:add:need_to_activate.png?direct&800 |}}
-After that, it will be ready to turn it on.
-{{ conn:add:need_to_turn_on.png?direct&800 |}}
-Here is a connection established and data acquired.
 ==== Diagnostic preset registers ====
 There are also a diagnostic solution for your project included. \\
 It is called "WebHMI Health registers".
-{{ conn:add:health_reg.png?direct&800 |}}
+{{ ::add_health_registers.png?direct&600 |}}
- It is a bunch of registers, which intended to show the status of WebHMI.
+It is a bunch of registers, which intended to show the status of WebHMI. The loggin option is turned on for them, so you can immediatly analize the system behaviour in custom graphs.
-{{ conn:add:health_reg_works.png?direct&800 |}}
-It is also logging enabled by default to make it possible create a graph with average load or input voltage for example.
-{{ conn:add:create_custom_graph.png?direct&800 |}}
-{{ conn:add:custom_graph_settings.png?direct&800 |}}
+{{ ::health_registers_example.png?direct&600 |}}
 If some device can be nested inside another (e.g. 7bit(tm) AipPoint sensor inside 7bit(tm) AirGate MQTT connection or WebHMI Health registers inside other WebHMI internal connection) the option to create a category in that connection will be offered.