connection_of_additional_rs-232_422_485_ports
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Next revision | |||
— | connection_of_additional_rs-232_422_485_ports [2018/12/10 14:44] – created emozolyak | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Additional COM ports ====== | ||
+ | You can add additional COM ports to WebHMI using USB-COM converters. Поддерживаются распространенные чипы таких производителей: | ||
+ | |||
+ | *FTDI | ||
+ | *CP2103 Silicon Labs | ||
+ | *Prolific PL2303 | ||
+ | *QinHeng Electronics CH340/341 | ||
+ | |||
+ | Attention: the operation modes such an extra port will support depends on specific manufacturer' | ||
+ | implementatoin and drivers provided. In some cases, devices have been discovered being unable to work on certain | ||
+ | speed, process parity bit etc. | ||
+ | | ||
+ | After installing such a converter in the system, when configuring connections, | ||
+ | |||
+ | {{:: | ||
+ | |||
+ | A special case of such a connection can be a direct connection of a PLC or other device to the USB port of WebHMI (usually a micro USB cable) directly. Onboard the PLC, in most cases, one of the above-mentioned USB-COM chips is installed. |
connection_of_additional_rs-232_422_485_ports.txt · Last modified: 2023/04/25 11:42 by emozolyak