connecting_to_s7-1200
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
connecting_to_s7-1200 [2021/07/23 14:26] – [Change protection options in the CPU settings] emozolyak | connecting_to_s7-1200 [2021/07/23 14:28] – [Check network connection details] emozolyak | ||
---|---|---|---|
Line 15: | Line 15: | ||
{{ : | {{ : | ||
- | Also, from the controller settings in the TIA portal project, it is necessary to take its IP address and TSAP (this is the device address in the COTP protocol. It is indicated in hexadecimal format.The high byte denotes the access type (by default 03) .The low byte consists of two Rack values (by default 0) and Slot (default 1). See Siemens documentation for controllers for more details). | + | ==== Check network connection details ==== |
+ | |||
+ | From the controller settings in the TIA portal project, it is necessary to take its IP address and TSAP (this is the device address in the COTP protocol. It is indicated in hexadecimal format.The high byte denotes the access type (by default 03). The low byte consists of two Rack values (by default 0) and Slot (default 1). See Siemens documentation for controllers for more details). | ||
Example of setting up a connection to the S7 1200 PLC in WebHMI: | Example of setting up a connection to the S7 1200 PLC in WebHMI: | ||
- | {{:: | + | {{ :: |
After that, you can create registers, using for them the standard notation of memory area addresses in Siemens PLCs - QB0.0, VW0, etc. For more information, | After that, you can create registers, using for them the standard notation of memory area addresses in Siemens PLCs - QB0.0, VW0, etc. For more information, |
connecting_to_s7-1200.txt · Last modified: 2023/09/07 17:47 by emozolyak