connecting_to_s7-1200
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
connecting_to_s7-1200 [2021/07/23 14:18] – emozolyak | connecting_to_s7-1200 [2021/07/23 14:26] – [Change protection options in the CPU settings] emozolyak | ||
---|---|---|---|
Line 6: | Line 6: | ||
1. Allow GET / PUT commands from third-party partners (in firmware revisions of S7-1200 lower than 4th version, these commands are allowed by default). | 1. Allow GET / PUT commands from third-party partners (in firmware revisions of S7-1200 lower than 4th version, these commands are allowed by default). | ||
+ | |||
2. Enable Full Access in " | 2. Enable Full Access in " | ||
- | {{ :: | + | {{ :: |
+ | |||
+ | ==== Disable Optimized Block Access for the Data Blocks you are going to exchange with. ==== | ||
- | 3. Disable Optimized Block Access for the Data Blocks you are going to exchange with. | + | {{ :optimized_check_box.png?direct |}} |
- | {{:: | + | |
Also, from the controller settings in the TIA portal project, it is necessary to take its IP address and TSAP (this is the device address in the COTP protocol. It is indicated in hexadecimal format.The high byte denotes the access type (by default 03) .The low byte consists of two Rack values (by default 0) and Slot (default 1). See Siemens documentation for controllers for more details). | Also, from the controller settings in the TIA portal project, it is necessary to take its IP address and TSAP (this is the device address in the COTP protocol. It is indicated in hexadecimal format.The high byte denotes the access type (by default 03) .The low byte consists of two Rack values (by default 0) and Slot (default 1). See Siemens documentation for controllers for more details). |
connecting_to_s7-1200.txt · Last modified: 2023/09/07 17:47 by emozolyak