connecting_to_melsec
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| connecting_to_melsec [2021/07/23 14:29] – emozolyak | connecting_to_melsec [2021/07/23 14:32] – emozolyak | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Connecting to Mitsubishi PLC with MELSEC protocol ====== | ====== Connecting to Mitsubishi PLC with MELSEC protocol ====== | ||
| + | ---- | ||
| + | |||
| + | {{ :: | ||
| To work with Mitsubishi PLCs supporting the MELSEC protocol (the generation which is programmed in __GX Works3__ eng. tool), it must be first configured the network configuration and explicitly indicated that there will be a host (in our case WebHMI) in the network that will poll the PLC with this protocol. This is done in the visual design environment of GX Works3. You need to go to the Parameter / FX5U CPU / Module parameter / Ethernet port and ' | To work with Mitsubishi PLCs supporting the MELSEC protocol (the generation which is programmed in __GX Works3__ eng. tool), it must be first configured the network configuration and explicitly indicated that there will be a host (in our case WebHMI) in the network that will poll the PLC with this protocol. This is done in the visual design environment of GX Works3. You need to go to the Parameter / FX5U CPU / Module parameter / Ethernet port and ' | ||
connecting_to_melsec.txt · Last modified: 2023/05/31 11:36 by emozolyak