Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
| configuration_reset [2019/01/08 12:18] – [WebHMI Reset method (from networking menu)] emozolyak | configuration_reset [2019/01/08 12:26] – [Network settings reset] emozolyak |
|---|
| ===== Network settings reset ===== | ===== Network settings reset ===== |
| |
| To reset the network settings, press and hold the 'Reset' button (located on the front panel of the device) when the device is turned on. After a while (approximately after 20-30 seconds, depending on the version of the firmware maybe longer) the red 'Error' LED will flash. Continue to hold down the 'Reset' button. After the first flashing, the 'Error' LED goes out and then lights up for a few seconds again. | To reset the network settings, press and hold the 'Reset' button (located on the front panel of the device) when the device is turned on. |
| | |
| | {{ ::net_conf_button.png?direct&200 |}} |
| | |
| | After a while (approximately after 20-30 seconds, depending on the version of the firmware maybe longer) the red 'Error' LED will flash. Continue to hold down the 'Reset' button. After the first flashing, the 'Error' LED goes out and then lights up for a few seconds again. |
| |
| At this point, the 'Reset' button can already be released. The cleaning operation may take several seconds or more. After reset, the system will reboot again to apply the new settings. | At this point, the 'Reset' button can already be released. The cleaning operation may take several seconds or more. After reset, the system will reboot again to apply the new settings. |
