Differences

This shows you the differences between two versions of the page.

--- configuration_reset [2021/08/06 14:56] – emozolyak
+++ configuration_reset [2022/01/14 21:40] (current) – ↷ Links adapted because of a move operation 127.0.0.1
@@ Line 1: / Line 1: @@
-{{ :menu-icon-reset.png?nolink&40|}}
+{{ network:menu-icon-reset.png?nolink&40|}}
 ====== Configuration reset ======
@@ Line 22: / Line 22: @@
 === Fw versions 3.6 and higher (popup setup window) ===
-{{ setup_menu_prj_clean.png }}
+{{ network:setup_menu_prj_clean.png }}
-{{ :clean_project_options_highlighted.png?direct&600 |}}
+{{ network:clean_project_options_highlighted.png?direct&600 |}}
 === Fw version 3.5 and low (side setup menu) ===
-{{clear_project.png?direct}}
+{{network:clear_project.png?direct}}
 <wrap em>The system will reset all settings and collected data. Network setting will not be affected.
@@ Line 34: / Line 34: @@
-{{::net_conf_reset.png?direct|}}
+{{network:net_conf_reset.png?direct|}}
 ===== Network settings reset =====
 The network configuration reset - can only be made using special routine with hardware 'Reset' button. To reset the network settings, press and hold the 'Reset' button (located on the front panel of the device) when the device is turned off. Then turn the device on while keeping button pressed.
-{{ ::net_conf_button.png?direct&200 |}}
+{{ network:net_conf_button.png?direct&200 |}}
 After a while (approximately after 20-30 seconds, depending on the version of the firmware maybe longer) the red 'Error' LED will flash. Continue to hold down the 'Reset' button. After the first flashing, the 'Error' LED goes out and then lights up for a few seconds again.