Differences

This shows you the differences between two versions of the page.

--- configuration_reset [2021/07/20 15:50] – [Clear project data method] emozolyak
+++ configuration_reset [2021/07/21 08:31] – [Clear project data method] emozolyak
@@ Line 4: / Line 4: @@
-  *Network configuration reset - can only be made using special routine with hardware 'Reset' button.
@@ Line 12: / Line 12: @@
 ===== Project configuration reset =====
+Project configuration reset - can be made in 3 ways:
+  *from the project itself - use Setup / Clean project & data menu
+  *from the network configuration ( WebHMI/Network/ Reset menu)
+  *remove SD card and format it
 ==== Clear project data method ====
-*Project configuration reset - can be made in 2 ways:
+=== Fw versions 3.6 and higher (popup setup window) ===
-  *from the project itself - Setup / Clean project & data menu
-  *from the network configuration ( WebHMI/Network/ Reset menu)
+{{ setup_menu_prj_clean.png }}
+{{ :clean_project_options_highlighted.png?direct&600 |}}
+=== Fw version 3.5 and low (side setup menu) ===
 {{clear_project.png?direct}}
-If you select "WebHMI project configuration and all collected data" option system will reset all settings and collected data. Network setting will not be affected.
+<wrap em>The system will reset all settings and collected data. Network setting will not be affected.
+</wrap>
 ==== From networking menu method ====
@@ Line 31: / Line 36: @@
 ===== Network settings reset =====
-To reset the network settings, press and hold the 'Reset' button (located on the front panel of the device) when the device is turned off. Then turn the device on while keeping button pressed.
+The network configuration reset - can only be made using special routine with hardware 'Reset' button. To reset the network settings, press and hold the 'Reset' button (located on the front panel of the device) when the device is turned off. Then turn the device on while keeping button pressed.
 {{ ::net_conf_button.png?direct&200 |}}