configuration_reset
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
configuration_reset [2019/01/08 12:18] – [WebHMI Reset method (from networking menu)] emozolyak | configuration_reset [2021/07/20 15:49] – [Clear project data method] emozolyak | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Configuration reset ====== | ====== Configuration reset ====== | ||
- | There are two parts of the WebHMI' | + | There are two parts of the WebHMI' |
- | | + | |
*Network configuration reset - can only be made using special routine with hardware ' | *Network configuration reset - can only be made using special routine with hardware ' | ||
Line 14: | Line 14: | ||
==== Clear project data method ==== | ==== Clear project data method ==== | ||
+ | *Project configuration reset - can be made in 2 ways: | ||
+ | |||
+ | *from the project itself - Setup / Clean project menu | ||
+ | *from the network configuration ( WebHMI/ | ||
The menu item Clear project (**Setup / Clear project**) allows you to clear project data: | The menu item Clear project (**Setup / Clear project**) allows you to clear project data: | ||
Line 26: | Line 30: | ||
===== Network settings reset ===== | ===== Network settings reset ===== | ||
- | To reset the network settings, press and hold the ' | + | To reset the network settings, press and hold the ' |
+ | |||
+ | {{ :: | ||
+ | |||
+ | After a while (approximately after 20-30 seconds, depending on the version of the firmware maybe longer) the red ' | ||
At this point, the ' | At this point, the ' |
configuration_reset.txt · Last modified: 2022/01/14 21:40 by 127.0.0.1