Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
check_resource_meter_readings [2019/02/27 15:23] emozolyak |
check_resource_meter_readings [2019/02/27 15:30] (current) emozolyak |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Check resource meters readings ====== | ====== Check resource meters readings ====== | ||
| - | |||
| - | In the WebHMI project it is possible to mark some registers as resource meter readings. Then in the Level2 reports various reports regarding resource consumption will be available. | ||
| - | |||
| - | In the register's properties tab, there is a special //Resources// tab for this: | ||
| - | |||
| - | {{ ::resource_select_for_meter.png?direct |}} | ||
| - | |||
| - | You can choose meter resource: | ||
| - | ***Electricity** | ||
| - | ***Gas** | ||
| - | ***Heat** | ||
| - | ***Water** | ||
| - | ***Hot water** | ||
| - | |||
| - | **Title**: this meter name will be shown in the L2 reports. | ||
| - | |||
| - | **Main** meter: If the meter is selected as //Main//, then other meters of the same type will be considered as contributors to the whole resource consumption. | ||
| - | |||
| - | **Send meter reading** must be checked for using resource reports in Level2. | ||
| The basic common task in recource menagement is to verify meters reading for the period. This link is available here: | The basic common task in recource menagement is to verify meters reading for the period. This link is available here: | ||
Page Tools
